| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: ti-ads1298: add bounds check to pga_settings index
ads1298_pga_settings has 7 elements but ADS1298_MASK_CH_PGA can yield
values 0-7. If it yields a value >= 7, this causes an out-of-bounds
array access. Add a bounds check and return -EINVAL if the index
is out of range.
Note that the remaining value b111 is reserved so should not be seen
in a correctly functioning system. |
| In the Linux kernel, the following vulnerability has been resolved:
serial: 8250_dw: unregister 8250 port if clk_notifier_register() fails
dw8250_probe() registers the 8250 port via serial8250_register_8250_port()
and then, if the device has a clock, registers a clock notifier. If
clk_notifier_register() fails, probe returns the error but leaves the
8250 port registered. The matching serial8250_unregister_port() lives
in dw8250_remove(), which is not called when probe fails, so the port
slot stays occupied until the device is rebound or the system is
rebooted. The devm-allocated driver data is freed while the port still
references it (via the saved private_data and serial_in/serial_out
callbacks), so any access to that port slot before a rebind is a
use-after-free hazard.
Unregister the port on the clk_notifier_register() error path. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: reject non-VALID session in compound request branch
smb2_check_user_session() takes a shortcut for any operation that is not
the first in a COMPOUND request: it reuses work->sess (the session bound by
the first operation) and validates only the SessionId, then returns
"valid". It never re-checks work->sess->state == SMB2_SESSION_VALID, and a
SessionId of 0xFFFFFFFFFFFFFFFF (ULLONG_MAX, the MS-SMB2 related-operation
value) skips even the id comparison. The standalone path
(ksmbd_session_lookup_all() plus the SESSION_SETUP state machine) does
enforce the VALID state; the compound branch bypasses all of it.
A SESSION_SETUP carrying only an NTLM Type-1 (NtLmNegotiate) blob publishes
a fresh SMB2_SESSION_IN_PROGRESS session whose sess->user is still NULL
(->user is assigned later, by ntlm_authenticate()). Used as operation 1 of
a COMPOUND with operation 2 = TREE_CONNECT (related, SessionId=ULLONG_MAX,
\\host\IPC$), the tree-connect then runs on that IN_PROGRESS session and
reaches ksmbd_ipc_tree_connect_request(), which dereferences
user_name(sess->user) with sess->user == NULL (transport_ipc.c:687/701/704)
-> remote NULL-pointer dereference and a kernel Oops that wedges the ksmbd
worker for all clients.
Reject any non-first compound operation that lands on a session which is
not SMB2_SESSION_VALID, mirroring the validity the standalone lookup path
enforces. SESSION_SETUP itself legitimately runs on an IN_PROGRESS session,
but it is never carried as a non-first compound operation, so multi-leg
authentication is unaffected by this check. |
| In the Linux kernel, the following vulnerability has been resolved:
virtiofs: fix UAF on submount umount
iput() called from fuse_release_end() can Oops if the super block has
already been destroyed. Normally this is prevented by waiting for
num_waiting to go down to zero before commencing with super block shutdown.
This only works, however, for the last submount instance, as the wait
counter is per connection, not per superblock.
Revert to using synchronous release requests for the auto_submounts case,
which is virtiofs only at this time. |
| In the Linux kernel, the following vulnerability has been resolved:
media: rzv2h-ivc: Fix concurrent buffer list access
The list of buffers (`rzv2h_ivc::buffers.queue`) is protected by a
spinlock (`rzv2h_ivc::buffers.lock`). However, in
`rzv2h_ivc_transfer_buffer()`, which runs in a separate workqueue, the
`list_del()` call is executed without holding the spinlock, which makes
it possible for the list to be concurrently modified
Fix that by removing a buffer from the list in the lock protected section.
[assign ivc->buffers.curr in critical section as reported by Barnabas] |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vce: Prevent partial address patches
In the case that only one of lo/hi is valid, the patching could result
in a bad address written to in FW. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: zero-initialize GART table on allocation
GART TLB is flushed after unmapping but not after mapping. Since
amdgpu_bo_create_kernel() does not zero-initialize the buffer, when a
single PTE is written the TLB may speculatively load other uninitialized
entries from the same cacheline. Those garbage entries can appear valid,
and a subsequent write to another PTE in the same cacheline may cause the
GPU to use a stale garbage PTE from the TLB.
Fix this by calling memset_io() to zero-initialize the GART table with
gart_pte_flags immediately after allocation.
Using AMDGPU_GEM_CREATE_VRAM_CLEARED, SDMA-based clear will not work
since SDMA needs GART to be initialized to work.
(cherry picked from commit d9af8263b82b6eaa60c5718e0c6631c5037e4b24) |
| In the Linux kernel, the following vulnerability has been resolved:
mm/vma: do not try to unmap a VMA if mmap_prepare() invoked from mmap()
The mmap_prepare hook functionality includes the ability to invoke
mmap_prepare() from the mmap() hook of existing 'stacked' drivers, that is
ones which are capable of calling the mmap hooks of other drivers/file
systems (e.g. overlayfs, shm).
As part of the mmap_prepare action functionality, we deal with errors by
unmapping the VMA should one arise. This works in the usual mmap_prepare
case, as we invoke this action at the last moment, when the VMA is
established in the maple tree.
However, the mmap() hook passes a not-fully-established VMA pointer to the
caller (which is the motivation behind the mmap_prepare() work), which is
detached.
So attempting to unmap a VMA in this state will be problematic, with the
most obvious symptom being a warning in vma_mark_detached(), because the
VMA is already detached.
It's also unncessary - the mmap() handler will clean up the VMA on error.
So to fix this issue, this patch propagates whether or not an mmap action
is being completed via the compatibility layer or directly.
If the former, then we do not attempt VMA cleanup, if the latter, then we
do.
This patch also updates the userland VMA tests to reflect the change. |
| In the Linux kernel, the following vulnerability has been resolved:
udf: reject descriptors with oversized CRC length
udf_read_tagged() skips CRC verification when descCRCLength +
sizeof(struct tag) exceeds the block size. A crafted UDF image can
set descCRCLength to an oversized value to bypass CRC validation
entirely; the descriptor is then accepted based solely on the 8-bit
tag checksum, which is trivially recomputable.
Reject such descriptors instead of silently accepting them. A
legitimate single-block descriptor should never have a CRC length that
exceeds the block. |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix fsck inconsistency caused by incorrect nat_entry flag usage
f2fs_need_dentry_mark() reads nat_entry flags without mutual exclusion
with the checkpoint path, which can result in an incorrect inode block
marking state. The scenario is as follows:
create & write & fsync 'file A' write checkpoint
- f2fs_do_sync_file // inline inode
- f2fs_write_inode // inode folio is dirty
- f2fs_write_checkpoint
- f2fs_flush_merged_writes
- f2fs_sync_node_pages
- f2fs_fsync_node_pages // no dirty node
- f2fs_need_inode_block_update // return true
- f2fs_fsync_node_pages // inode dirtied
- f2fs_need_dentry_mark //return true
- f2fs_flush_nat_entries
- f2fs_write_checkpoint end
- __write_node_folio // inode with DENT_BIT_SHIFT set
SPO, "fsck --dry-run" find inode has already checkpointed but still
with DENT_BIT_SHIFT set
The state observed by f2fs_need_dentry_mark() can differ from the state
observed in __write_node_folio() after acquiring sbi->node_write. The
root cause is that the semantics of IS_CHECKPOINTED and
HAS_FSYNCED_INODE are only guaranteed after the checkpoint write has
fully completed.
This patch moves set_dentry_mark() into __write_node_folio() and
protects it with the sbi->node_write lock. |
| SurrealDB before 2.2.6, 2.3.6, and 2.1.8 (and 3.0.0-alpha.7 and earlier) fails to validate DNS-resolved hostnames against --deny-net network access restrictions in its http::* functions. An authenticated user can invoke http::<fn>(<url>) with a hostname that resolves to a denied IP address, causing the server to issue the request anyway and return the response. This bypasses network access controls, allowing access to restricted internal endpoints and potentially retrieving or altering sensitive information and credentials, depending on the deployment. |
| SurrealDB before 2.0.5, 2.1.x before 2.1.5, and 2.2.x before 2.2.2 does not enforce a default execution-time limit on embedded JavaScript scripting functions when the scripting capability is explicitly enabled (via --allow-scripting or --allow-all). An authenticated attacker can submit long-running JavaScript functions to exhaust server resources and cause a denial of service. Scripting is disabled by default. |
| A security flaw has been discovered in nextlevelbuilder GoClaw up to 3.13.2. Affected by this vulnerability is the function extractBin/RequestApproval/matchesAllowlist of the file internal/tools/exec_approval.go. The manipulation results in incorrect authorization. The exploit has been released to the public and may be used for attacks. |
| Statamic is a Laravel and Git powered content management system (CMS). Prior to 5.73.24 and 6.20.1, form submission values in src/Forms/Exporters/CsvExporter.php were not neutralized for spreadsheet formula characters when exported to CSV. A submission containing a value beginning with a formula trigger character, such as =, +, -, or @, could be interpreted as a live formula when a Control Panel user opens the export in a spreadsheet application. Form submissions can come from unauthenticated front-end visitors, so the malicious value can be supplied by an anonymous user and is later triggered by an editor opening the export. This issue is fixed in versions 5.73.24 and 6.20.1. |
| IBM Langflow OSS 1.0.0 through 1.10.0 allows an authenticated attacker to read arbitrary files including the JWT signing key and forge authentication tokens for any user. |
| IBM Cognos Analytics 12.1.3 GA Version with build number through 12.1.3-2606251736 could allow an attacker to obtain incorrect report summary results or cause report-processing failures due to a race condition in the Agentic AI assistant's concurrent request-handling logic when multiple authenticated users submit report-related tasks simultaneously. |
| A security flaw has been discovered in zevorn rt-claw up to 0.2.0. This impacts the function receiver_thread of the file claw/services/swarm/swarm.c of the component http_request. Performing a manipulation results in server-side request forgery. It is possible to initiate the attack remotely. The exploit has been released to the public and may be used for attacks. The project was informed of the problem early through an issue report but has not responded yet. |
| Stoat for Android exports the chat.stoat.activities.ShareTargetActivity component (reachable to any process on the device via the android.intent.action.SEND intent) and accepts the file to share as a URI supplied through the android.intent.extra.STREAM extra. The activity does not validate or filter the incoming URI before using it as the outgoing attachment, so a caller can pass a file:// URI pointing at the application's own internal storage (for example /data/data/chat.revolt/databases/revolt.db, cached authentication token files, or preferences) and have the app treat that internal file as a user-selected attachment. An attacker who can invoke intents on the victim's device (via ADB access, a co-installed malicious application, or any other route that reaches Android's intent dispatch) can launch ShareTargetActivity with such a URI and cause the victim, on a single channel-selection interaction, to send the internal file to any Stoat channel or user of the attacker's choosing. The composer displays the attachment as \"attachment\" with no filename indication, so the victim has no visible signal that the file being sent is their own internal application data. Consequences include disclosure of the local Stoat database (message history, contact list, cached content), disclosure of authentication tokens permitting full account takeover, and disclosure of any other file readable by the app process. |
| IBM Langflow OSS 1.0.0 through 1.10.1 Langflow could allow an authenticated user to execute arbitrary commands with elevated privileges on the system due to improper validation of user supplied input in the Python Interpreter component. |
| Remote command execution vulnerability in SE-elektronic GmbH E-DDC3.3 affecting versions 03.07.03 and higher. An attacker could send different commands from the operating system to the system via the web configuration functionality of the device. |
