| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
mm/zone_device: do not touch device folio after calling ->folio_free()
The contents of a device folio can immediately change after calling
->folio_free(), as the folio may be reallocated by a driver with a
different order. Instead of touching the folio again to extract the
pgmap, use the local stack variable when calling percpu_ref_put_many(). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_uart: fix UAFs and race conditions in close and init paths
Vulnerabilities leading to Use-After-Free (UAF) and Null Pointer
Dereference (NPD) conditions were observed in the lifecycle management
of hci_uart.
The primary issue arises because the workqueues (init_ready and
write_work) are only flushed/cancelled if the HCI_UART_PROTO_READY
flag is set during TTY close. If a hangup occurs before setup completes,
hci_uart_tty_close() skips the teardown of these workqueues and
proceeds to free the `hu` struct. When the scheduled work executes
later, it blindly dereferences the freed `hu` struct.
Furthermore, several data races and UAFs were identified in the teardown
sequence:
1. Calling hci_uart_flush() from hci_uart_close() without effectively
disabling write_work causes a race condition where both can concurrently
double-free hu->tx_skb. This happens because protocol timers can
concurrently invoke hci_uart_tx_wakeup() and requeue write_work.
2. Calling hci_free_dev(hdev) before hu->proto->close(hu) causes a UAF
when vendor specific protocol close callbacks dereference hu->hdev.
3. In the initialization error paths, failing to take the proto_lock
write lock before clearing PROTO_READY leads to races with active
readers. Additionally, hci_uart_tty_receive() accesses hu->hdev
outside the read lock, leading to UAFs if the initialization error
path frees hdev concurrently.
Fix these synchronization and lifecycle issues by:
1. Re-ordering hci_uart_tty_close() to clear HCI_UART_PROTO_READY first,
followed immediately by a cancel_work_sync(&hu->write_work). Clearing
the flag locks out concurrent protocol timers from successfully invoking
hci_uart_tx_wakeup(), effectively rendering the cancellation permanent
and preventing the tx_skb double-free.
2. Note: Clearing PROTO_READY early causes hci_uart_close() to skip
hu->proto->flush(). This is perfectly safe in the tty_close path
because hu->proto->close() executes shortly after, which intrinsically
purges all protocol SKB queues and tears down the state.
3. Relocating hu->proto->close(hu) strictly prior to hci_free_dev(hdev)
across all close and error paths to prevent vendor-level UAFs.
4. Moving the hdev->stat.byte_rx increment in hci_uart_tty_receive()
inside the proto_lock read-side critical section to safely synchronize
with device unregistration.
5. Adding cancel_work_sync(&hu->write_work) to hci_uart_close() to safely
flush the workqueue before hci_uart_flush() is invoked via the HCI core.
6. Utilizing cancel_work_sync() instead of disable_work_sync() across
all paths to prevent permanently breaking user-space retry capabilities. |
| Inappropriate implementation in DevTools in Google Chrome prior to 149.0.7827.115 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Inappropriate implementation in Extensions in Google Chrome prior to 149.0.7827.115 allowed a remote attacker who had compromised the renderer process to bypass site isolation via a crafted HTML page. (Chromium security severity: High) |
| Use after free in Cast in Google Chrome prior to 149.0.7827.115 allowed an attacker on the local network segment to potentially perform a sandbox escape via malicious network traffic. (Chromium security severity: High) |
| Use after free in Autofill in Google Chrome prior to 149.0.7827.115 allowed a remote attacker who had compromised the renderer process to obtain potentially sensitive information from process memory via a crafted HTML page. (Chromium security severity: High) |
| Heap buffer overflow in Codecs in Google Chrome on Linux and ChromeOS prior to 149.0.7827.115 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Insufficient policy enforcement in DevTools in Google Chrome prior to 149.0.7827.115 allowed a remote attacker to bypass same origin policy via a crafted HTML page. (Chromium security severity: High) |
| Inappropriate implementation in Headless in Google Chrome prior to 149.0.7827.115 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Race in V8 in Google Chrome prior to 144.0.7559.99 allowed a remote attacker to potentially exploit type confusion via a crafted HTML page. (Chromium security severity: High) |
| Insufficient validation of untrusted input in Network in Google Chrome prior to 149.0.7827.115 allowed a remote attacker who had compromised the renderer process to leak cross-origin data via a crafted HTML page. (Chromium security severity: High) |
| Out of bounds read in VideoCapture in Google Chrome prior to 149.0.7827.115 allowed a remote attacker who had compromised the GPU process to obtain potentially sensitive information from process memory via a crafted HTML page. (Chromium security severity: High) |
| Insufficient validation of untrusted input in Linux Toolkit Theming in Google Chrome on Linux prior to 149.0.7827.115 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a malicious file. (Chromium security severity: High) |
| Use after free in Network in Google Chrome prior to 149.0.7827.115 allowed an attacker in a privileged network position to potentially exploit heap corruption via malicious network traffic. (Chromium security severity: High) |
| Use after free in DigitalCredentials in Google Chrome prior to 149.0.7827.115 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: Critical) |
| Adobe Campaign Classic (ACC) versions 7.4.3 build 9394 and earlier are affected by an Incorrect Authorization vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue does not require user interaction. Scope is changed. |
| In the Linux kernel, the following vulnerability has been resolved:
net/rds: reset op_nents when zerocopy page pin fails
When iov_iter_get_pages2() fails in rds_message_zcopy_from_user(),
the pinned pages are released with put_page(), and
rm->data.op_mmp_znotifier is cleared. But we fail to properly
clear rm->data.op_nents.
Later when rds_message_purge() is called from rds_sendmsg() the
cleanup loop iterates over the incorrectly non zero number of
op_nents and frees them again.
Fix this by properly resetting op_nents when it should be in
rds_message_zcopy_from_user(). |
| In the Linux kernel, the following vulnerability has been resolved:
af_unix: Initialise scc_index in unix_add_edge().
Quang Le reported that the AF_UNIX GC could garbage-collect a
receive queue of an alive in-flight socket, with a nice repro.
The repro consists of three stages.
1)
1-a. Create a single cyclic reference with many sockets
1-b. close() all sockets
1-c. Trigger GC
2)
2-a. Pass sk-A to an embryo sk-B
2-b. Pass sk-X to sk-X
2-c. Trigger GC
3)
3-a. accept() the embryo sk-B
3-b. Pass sk-B to sk-C
3-c. close() the in-flight sk-A
3-d. Trigger GC
As of 2-c, sk-A and sk-X are linked to unix_unvisited_vertices,
and unix_walk_scc() groups them into two different SCCs:
unix_sk(sk-A)->vertex->scc_index = 2 (UNIX_VERTEX_INDEX_START)
unix_sk(sk-X)->vertex->scc_index = 3
Once GC completes, unix_graph_grouped is set to true.
Also, unix_graph_maybe_cyclic is set to true due to sk-X's
cyclic self-reference, which makes close() trigger GC.
At 3-b, unix_add_edge() allocates unix_sk(sk-B)->vertex and
links it to unix_unvisited_vertices.
unix_update_graph() is called at 3-a. and 3-b., but neither
unix_graph_grouped nor unix_graph_maybe_cyclic is changed
because both sk-B's listener and sk-C are not in-flight.
3-c decrements sk-A's file refcnt to 1.
Since unix_graph_grouped is true at 3-d, unix_walk_scc_fast()
is finally called and iterates 3 sockets sk-A, sk-B, and sk-X:
sk-A -> sk-B (-> sk-C)
sk-X -> sk-X
This is totally fine. All of them are not yet close()d and
should be grouped into different SCCs.
However, unix_vertex_dead() misjudges that sk-A and sk-B are
in the same SCC and sk-A is dead.
unix_sk(sk-A)->scc_index == unix_sk(sk-B)->scc_index <-- Wrong!
&&
sk-A's file refcnt == unix_sk(sk-A)->vertex->out_degree
^-- 1 in-flight count for sk-B
-> sk-A is dead !?
The problem is that unix_add_edge() does not initialise scc_index.
Stage 1) is used for heap spraying, making a newly allocated
vertex have vertex->scc_index == 2 (UNIX_VERTEX_INDEX_START)
set by unix_walk_scc() at 1-c.
Let's track the max SCC index from the previous unix_walk_scc()
call and assign the max + 1 to a new vertex's scc_index.
This way, we can continue to avoid Tarjan's algorithm while
preventing misjudgments. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: bcm-sba-raid: fix device leak on probe
Make sure to drop the reference taken when looking up the mailbox device
during probe on probe failures and on driver unbind. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/core: Check for the presence of LS_NLA_TYPE_DGID correctly
The netlink response for RDMA_NL_LS_OP_IP_RESOLVE should always have a
LS_NLA_TYPE_DGID attribute, it is invalid if it does not.
Use the nl parsing logic properly and call nla_parse_deprecated() to fill
the nlattrs array and then directly index that array to get the data for
the DGID. Just fail if it is NULL.
Remove the for loop searching for the nla, and squash the validation and
parsing into one function.
Fixes an uninitialized read from the stack triggered by userspace if it
does not provide the DGID to a kernel initiated RDMA_NL_LS_OP_IP_RESOLVE
query.
BUG: KMSAN: uninit-value in hex_byte_pack include/linux/hex.h:13 [inline]
BUG: KMSAN: uninit-value in ip6_string+0xef4/0x13a0 lib/vsprintf.c:1490
hex_byte_pack include/linux/hex.h:13 [inline]
ip6_string+0xef4/0x13a0 lib/vsprintf.c:1490
ip6_addr_string+0x18a/0x3e0 lib/vsprintf.c:1509
ip_addr_string+0x245/0xee0 lib/vsprintf.c:1633
pointer+0xc09/0x1bd0 lib/vsprintf.c:2542
vsnprintf+0xf8a/0x1bd0 lib/vsprintf.c:2930
vprintk_store+0x3ae/0x1530 kernel/printk/printk.c:2279
vprintk_emit+0x307/0xcd0 kernel/printk/printk.c:2426
vprintk_default+0x3f/0x50 kernel/printk/printk.c:2465
vprintk+0x36/0x50 kernel/printk/printk_safe.c:82
_printk+0x17e/0x1b0 kernel/printk/printk.c:2475
ib_nl_process_good_ip_rsep drivers/infiniband/core/addr.c:128 [inline]
ib_nl_handle_ip_res_resp+0x963/0x9d0 drivers/infiniband/core/addr.c:141
rdma_nl_rcv_msg drivers/infiniband/core/netlink.c:-1 [inline]
rdma_nl_rcv_skb drivers/infiniband/core/netlink.c:239 [inline]
rdma_nl_rcv+0xefa/0x11c0 drivers/infiniband/core/netlink.c:259
netlink_unicast_kernel net/netlink/af_netlink.c:1320 [inline]
netlink_unicast+0xf04/0x12b0 net/netlink/af_netlink.c:1346
netlink_sendmsg+0x10b3/0x1250 net/netlink/af_netlink.c:1896
sock_sendmsg_nosec net/socket.c:714 [inline]
__sock_sendmsg+0x333/0x3d0 net/socket.c:729
____sys_sendmsg+0x7e0/0xd80 net/socket.c:2617
___sys_sendmsg+0x271/0x3b0 net/socket.c:2671
__sys_sendmsg+0x1aa/0x300 net/socket.c:2703
__compat_sys_sendmsg net/compat.c:346 [inline]
__do_compat_sys_sendmsg net/compat.c:353 [inline]
__se_compat_sys_sendmsg net/compat.c:350 [inline]
__ia32_compat_sys_sendmsg+0xa4/0x100 net/compat.c:350
ia32_sys_call+0x3f6c/0x4310 arch/x86/include/generated/asm/syscalls_32.h:371
do_syscall_32_irqs_on arch/x86/entry/syscall_32.c:83 [inline]
__do_fast_syscall_32+0xb0/0x150 arch/x86/entry/syscall_32.c:306
do_fast_syscall_32+0x38/0x80 arch/x86/entry/syscall_32.c:331
do_SYSENTER_32+0x1f/0x30 arch/x86/entry/syscall_32.c:3 |
